AS 1154.1-2009 Insulator and conductor fittings for overhead power lines - Part 1 Performance, material, general requirements and dimensions.pdf

AS1154.1--2009
0→+→|Nooo
Australian Standarde
Insulator and conductor fittings for
overhead power lines
Part 1 Performance, material, general
requirements and dimensions
STANDARDS
Australia
This Australian Standard was prepared by Committee EL-010, Overhead Lines. It was
approved on behalf of the Council of Standards Australia on 4 November 2008
This Standard Was published on 12 February 2009
The following are represented on Committee EL-010
Australasian Railway Association
Australian Chamber of Commerce and Industry
e Australian Electrical and Electronic Manufacturers Association
e Australian Porcelain Insulators Association
Electricity Engineers Association, New Zealand
Energy Networks Association
This Standard was issued in draft form for comment as DR 07133
Standards Australia wishes to acknowledge the participation of the expert individuals that
contributed to the development of this Standard through their representation on the
Committee and through the public comment period
Keeping Standards up-to-date
Australian Standards are living documents that reflect progress in science, technology and
systems To maintain their curency, all Standards are periodically reviewed, and new editions
are published. Between editions, amendments may be issued
Standards may also be withdrawn. It is important that readers assure themselves they ar
using a current Standard, which should include any amendments that may have been
published since the Standard was published
Detailed information about Australian Standards, drafts, amendments and new projects can
befoundbyVisitingwww.standardsorg.au
Standards Australia welcomes suggestions for improvements, and encourages readers to
notify us immediately of any apparent inaccuracies or ambiguities. Contact us via email at
mail(@standards. org. au, or write to Standards Australia, GPO Box 476, Sydney, NSW 2001
TheStandardisdownloadedfromwww.bztxw.comStandardSharing
AS1154.1--2009
Australian Standarde
Insulator and conductor fittings for
overhead power lines
Part 1 Performance, material, general
requirements and dimensions
Originated as AS C345.1-1962 and AS C345.2-1967
Previous edition 2004
Fifth edition 2009
COPYRIGHT
O Standards Australia
All rights are reserved. No part of this work may be reproduced or copied in any forr
any means, electronic or mechanical, including photocopying, without the written
permission of the publisher
Published by Standards Australia GPO Box 476, Sydney, NSW 2001, Australia
ISBN0733790046